Frequently Asked Questions

Frequently Asked Questions


4x6" Headlights not working properly?

On your two low beam headlights only, there are 3 wires that go into your headlight plug. A low beam wire, a high beam wire, and a ground wire. On both low beam headlights, you want to swap the low beam wire with the ground wire. If that does not fix it then put it back and then swap the low beam and high beam wires.


7" LED Headlight Bucket Modification?

You need to trim out the center hole of the inner headlight bucket where the wiring comes through so the headlight will drop all the way into the bucket and allow the trim ring to go on. Should be able to use the stock ring and plug into the factory plug if your bike


Is the Halogen Headlight Lens, Glass or Plastic?

Lens is glass, not plastic
The lenses are glass, not plastic. The glass sounds deadened like plastic when you tap on it because it is glued to a plastic backing. I originally thought the same you did but I have dropped many of them by accident over the years and broke them to know that they are in fact glass.


Halo Headlight Wiring Instructions?

The red wires are power and the black wires are ground. Wire the set of red power wires into a power source and wire the set of black wires into a ground source.
You can splice the wiring into the headlight wiring OR the Park Light wiring OR Connect to a separate switch. I sell a halo ON/OFF Switch in my store also.


LED Halo Car / Truck Headlight Wiring?

the red wire goes to the battery power terminal
white wire goes go the parking lights power wire
yellow wire goes to the turn signal light power wire
black wire is the ground wire


7x6" LED Headlight Wiring Fix?

Use a test light to identify the low beam terminal, the high beam terminal and the ground terminal on the vehicles headlight plug. Then test the headlight and identify the low beam terminal, high beam terminal and the ground terminal.


HID Kit Set of 4 - Making one HID kit a high beam kit?

On one of the kits, remove the third terminal out of the backside of the connector. Using a small screw driver, push down on the tab on the front side of the third terminal will at the same time pulling the wire out from the backside. This will remove the third terminal from the plug. This kit will be used for both high beam headlights.


Halo Headlight modifications and install?

you may need to cut out the center hole of your headlight bucket for them to fit all the way in.
You also need to splice in the power and ground wires for the city light and the halo ring the halogen headlight bulb connections will plug into the factory plug connections.
Red wires are power and the black wires are ground