2 Pin Prong Terminal Relay Electronic Flasher 12 Volt LED Turn Signal Light
-
BrandCARQUEST
-
MPNTF552536
-
Warranty90 DAYS
-
Interchange Part NumberEFL1
-
Other Part Number552 / 536 / 575
-
Superseded Part Number552 / 536 / 575
-
Manufacturer Part NumberTF552/536
-
ConditionNew
-
Model NumberTF552/536
(1) 2 Terminal 12V LED Electrical Flasher
New 2-prong (2 terminal with ground wire) 12 Volt LED Flasher. Flasher is designed to replace stock turn signal flasher on most 1955 to present cars and trucks with 2 prong 12v systems. Flasher has NEGATIVE ground (flasher will NOT work with early 6v POSITIVE ground cars/truck or motorcycles). Replacement of the stock flasher is usually needed in order for the LED turn signals to operate as intended. Solves: hyper flashing, burnt out bulb indication, or non flashing when using led lights and led light bulbs.
We are also including a FREE "reverse polarity" adapter. If your turn signal flasher dock has the wires reversed, no need to disconnect, switch, and reinstall wires. Simply attach the adapter to the end of the flasher.
These flashers will also work with stock turn signals, so if you change back to stock lights, there will be no need to swap out the flasher
We also offer 3-prong LED flashers for most pre-1955 vehicles that have been converted to 12v
- Solve Turn Signal Problems: Hyper Flashing, No Flashing, or Burnt Out Bulb Indication when using LED Lights and LED Bulbs
- 2 Terminal Flasher / 2 Prong with Ground Wire
- Use with LED lights
- Max 20 Amps
-
2 x 1157/2057 18 SMD Light Bulbs for Turn Signal/Stop Lights - White
2 x 1157/2057 18 SMD Light Bulbs for Turn Signal/Stop Lights - White 18SMD-WHITE-PAIR -
75-82 Chevy Corvette LED Rear Bubble Tail Light Lamp Lens 1975 1976-1982 Set
75-82 Chevy Corvette LED Rear Bubble Tail Light Lamp Lens SET OF 4SET OF 4 New Red LED Bubble Tail Light LensesFits Left (Driver) & Right (Passenger) Sides25 White LED Bulbs in Each LensRed Polycarbonate LensesUses 1157 Plugs (Included)Fully Sealed ElectronicsEasy InstallationFits 1975-1982 Chevrolet Corvette1975-79 Note: Must Trim Plastic Mounting Legs to Match 1975-79 SizeLifetime WarrantySold as a Set of 4Required: 12V 2 Pin Prong Terminal Electronic Switch Relay LED Turn Signal Light Flasher - eBay item # 330977699404We Also Have These Lenses Available Individually Fits: 75-76-77-78-79-80-81-82-1975-1976-1977-1978-1979-1980-1981-1982 Chevy Corvette1 left in stock. Backorder available -
5-3/4 Red LED Halo Angel Eyes Projector Headlight H4 6000K HID Light Bulbs Set
THESE ARE CRYSTAL CLEAR PROJECTOR HEADLIGHTS WITH RED LED HALO RINGS! THIS IS FOR A SET OF ( 4 ) WITH 6000K HID XENON SUPER WHITE BULBS W/ BALLASTS AND RELAY HARNESSES! LED rings can be wired to be daytime running lights, turn signals, or stay on with the headlightsINCLUDES 6000K (WHITE COLOR) HIGH INTENSITY DISCHARGE (HID) HI/LOW BI-XENON SLIM BALLAST LIGHT BULB KITS! THIS LISTING IS FOR A NEW SET OF 4 OF 5-3/4" 12 VOLT HIGH/LOW BEAM PROJECTOR HEADLIGHTS WITH RED LEDS AND 6K HID KITS. THESE ARE GLASS HEADLIGHTS. THESE HAVE THE ORIGINAL 3 PRONG PLUG DESIGN ON THE BACK SO THEY WILL PLUG RIGHT INTO THE ORIGINAL WIRING HARNESS. INCLUDES 6000K BI-XENON HI/LOW SUPER WHITE HID KIT. THESE WILL FIT ANY CAR OR TRUCK THAT HAS 5 3/4 INCHES IN DIAMETER HEADLIGHTS. SOME MODIFICATION TO THE HEADLIGHT BUCKET OR WIRING MAY BE REQUIRED. HALO RING IS POWERED BY A 12V POWER WIRE AND A GROUND WIRE. SAE AND DOT APPROVED. THESE ARE GLASS AND WE WILL TAKE EXTRA CARE IN PACKAGING. INTERCHANGE: H5001 / H5006 / 4000 / 5001Backorder available -
2 Pin Prong 12V Terminal Relay Electronic LED Flasher Switch Turn Signal Light
(1) 2 Terminal 12V LED Electrical Flasher New 2-prong (2 terminal with ground wire) 12 Volt LED Flasher. Flasher is designed to replace stock turn signal flasher on most 1955 to present cars and trucks with 2 prong 12v systems. Flasher has NEGATIVE ground (flasher will NOT work with early 6v POSITIVE ground cars/truck or motorcycles). Replacement of the stock flasher is usually needed in order for the LED turn signals to operate as intended. Solves: hyper flashing, burnt out bulb indication, or non flashing when using led lights and led light bulbs. We are also including a FREE "reverse polarity" adapter. If your turn signal flasher dock has the wires reversed, no need to disconnect, switch, and reinstall wires. Simply attach the adapter to the end of the flasher. These flashers will also work with stock turn signals, so if you change back to stock lights, there will be no need to swap out the flasher We also offer 3-prong LED flashers for most pre-1955 vehicles that have been converted to 12v Solve Turn Signal Problems: Hyper Flashing, No Flashing, or Burnt Out Bulb Indication when using LED Lights and LED Bulbs 2 Terminal Flasher / 2 Prong with Ground Wire Use with LED lights Max 20 Amps
